STL file PRINT-IN-PLACE CUTE LUCKY CHICKEN・3D printing concept to obtain・Cults

The second mannequin in my assortment of cute fortunate animals. Faucet on its head and it’ll wave to you for as much as 1-2 minutes.

As with all my designs, I went by a number of iterations to good the mechanism and the printability of the mannequin with none assist constructions. All you want is an efficient mattress adhesion and good cooling for some clear overhangs.

No meeting is required!

The built-in compliant mechanism and printed spring enable for a frictionless design with massive tolerances which ought to make it doable to print this on virtually any FDM printer. SLA may work as nicely though it isn’t particularly designed for it.

This mannequin can maintain cash inside a dimension of 23 – 26 mm (0,9 – 1,02 inches) which makes this mannequin nice as a coin saver for purchasing carts. Alternatively, a printed weight may be inserted if you do not have becoming cash.

It’s additionally enjoyable to place the mannequin in your automobile’s dashboard because the bunny will begin waving in sync with the motion of your automobile whereas driving.

Should you appreciated this mannequin be at liberty to comply with me for extra cute waving fashions sooner or later.

IMPORTANT: Ensure that the springs shall be printed within the slicer preview. Listed here are some slicer-specific settings to be sure that the spring will end up appropriately.

For all Slicers
I might not use a brim for the mattress adhesion as it will likely be onerous to take away from the spring.

Prusa Slicer
Print Settings > Superior > Slicing > Slice hole closing radius > set the worth to 0 mm
(In case you are utilizing a model older than PrusaSlicer 2.5 go to Print Settings >Layers and perimeters > High quality > Detect skinny partitions > activate it)

Ultimaker Cura
No particular settings required
(In case you are utilizing a model older than Cura 5.0 go to Partitions > Print Skinny Partitions > activate it)

Bambu Slicer
(Superior settings > High quality > Precision > Slice hole closing radius > Set to 0 mm
(Superior settings > Power > Partitions > Detect skinny partitions > Activate

Basic settings

This mannequin is designed for a 0.4 mm nozzle/linewidth. If in case you have a much bigger or smaller nozzle put in in your printer I like to recommend you scale the mannequin up or down accordingly:
0.3 mm Nozzle => 75 % Scale
0.4 mm Nozzle => 100 % Scale
0.5 mm Nozzle => 125 % Scale
0.6 mm Nozzle => 150 % Scale
0.7 mm Nozzle => 175 % Scale

The mannequin is designed to be printed on its again because it comes with the file. Printing in another orientation will trigger the springs to fail.

Supportfree design. No assist is required.

A great print mattress adhesion will assure a profitable print, so be sure all the things is properly-leveled and possibly apply a twig adhesive in case your filament requires that.

At 100% scale, it prints in roughly 5 hours with 50 g of fabric.

Set the cooling to a excessive worth.

Watch out when eradicating the mannequin from the construct plate.

If in case you have any points with stringing its finest to take away the strings by hand to extend the swing time of the pendulum.

Glad printing!