Whats up guys, hope all is effectively. I’m attaching a desk leg and I would like to have the ability to give the surface 2 edges an actual good rounded look, however undecided the easiest way to do it? I attempted spherical nook and that didn’t work very effectively. 
I’m attaching a leg I made with the tough dimensions I would like and likewise connected a reference pic to indicate what I imply. Any assist can be vastly appreciated
Thanks
Jay
I’d in all probability use Fredo Nook on the leg at this level. You possibly can additionally do it with Observe Me however it might be simpler to do the roundovers that means earlier than trimming the highest and backside of the leg.
Thanks Dave! I went to my extension supervisor and I do have Fredo Nook however it’s not on my device bar ? I attempted to put in the extension once more and have it present up in my device bar however cant appear to search out it? What I’m I doing improper?
Jay
Do you could have the present variations of LibFredo6 and the Sketchucation ExtensionStore device put in?
I do have it ? I simply need it on my device bar Ideas?
Jay
Did you go to View>Toolbars and choose it?
Ought to I reset Dave in order that they are going to present up?
Whenever you set up a Fredo extension you need to restart SketchUp earlier than you may open its toolbar or use it.
Yep I attempted that a number of occasions ARGH!
I bought it Dave! Thanks!!!
Jay
