Sunday, December 31, 2023
HomeCreative IdeasEnter DFU Mode on Flight Controller for Betaflight and iNav Firmware

Enter DFU Mode on Flight Controller for Betaflight and iNav Firmware


Getting into DFU (Machine Firmware Improve) mode on a flight controller is crucial for flashing new firmware like Betaflight or iNav. Right here’s a step-by-step information on easy methods to do it utilizing CLI instructions or the boot button.

A few of the hyperlinks on this web page are affiliate hyperlinks. I obtain a fee (at no further price to you) should you make a purchase order after clicking on one in every of these affiliate hyperlinks. This helps help the free content material for the group on this web site. Please learn our Affiliate Hyperlink Coverage for extra info.

Utilizing Boot Button

flight controller fc boot bootloader button pads solder bridge

Practically all flight controllers have an onboard push button, referred to as the “Boot Button.” Holding down the boot button whereas connecting the USB cable will put the FC into DFU mode.

  1. Find the Boot Button: Discover the boot button in your flight controller. It’s normally small and labeled as ‘Boot’ or ‘DFU’.
  2. Press and Maintain the Button: Press and maintain the boot button.
  3. Hook up with PC: Whereas holding the button, join the flight controller to your laptop by way of USB.
  4. Launch the Button: As soon as related, you’ll be able to launch the boot button. The flight controller ought to now be in DFU mode.
  5. Firmware Flashing: Proceed with flashing the brand new firmware by means of the Betaflight or iNav Configurator.

Utilizing CLI Instructions

Betaflight Configurator Cli Bl Bootloader Dfu Command

In case your FC is put in contained in the FPV drone’s body, accessing the boot button might not at all times be potential. In such instances, you’ll be able to enter a command in Betaflight or iNav CLI to enter DFU mode.

  1. Hook up with Betaflight Configurator: Plug your flight controller into the pc and open the Betaflight Configurator.
  2. Open CLI Tab: Navigate to the CLI (Command Line Interface) tab within the configurator.
  3. Enter DFU Command: Sort bl within the CLI and press enter. This command ought to reboot the flight controller into DFU mode. bl stands for bootloader.
  4. Firmware Flashing: Your flight controller is now in DFU mode and prepared for firmware flashing.

Be aware: for iNav, the command to enter DFU mode is solely dfu

Know If You Are in DFU Mode?

In case your flight controller is in DFU mode, you must see “DFU” within the Ports dropdown field.

Betaflight Configurator Ports Dfu Mode

Suggestions

Conclusion

Getting into DFU mode can fluctuate barely relying on the flight controller mannequin, so check with your particular mannequin’s guide for any extra steps or variations.

RELATED ARTICLES

LEAVE A REPLY

Please enter your comment!
Please enter your name here

Most Popular

Recent Comments