In earlier variations of SU, when a mannequin is exported to Structure, the SketchUp Mannequin tray reveals “Protect Scale on Resize” unchecked.by default. I may scroll via my numerous pages of the mannequin and zoom in or out to the place I preferred the view and it might keep the place I left it.
Within the 2023 model of Structure, “Protect Scale” is checked by default. Now, I’ve to uncheck Protect Scale on EVERY web page to permit me to zoom and scale the web page as I would like it. A really large trouble when there are 20-30 pages that should be adjusted to the view I would like. Usually, I’ll click on on a web page, double click on within the view window and it scales to the view I created within the SU mannequin. Now, I’ve to uncheck Protect Scale earlier than every adjustment, and it has slowed the method of getting the mannequin into paper house.
There ought to be an possibility to show Protect Scale off by default or, go away it of prefer it was in earlier variations. Main ache!
Is it potential you’ve gotten saved a template that approach?
I don’t have that challenge.
I’m not seeing Protect Scale mechanically checked in LO2023. It doesn’t mechanically get checked till I set a scale. Very same conduct as in earlier variations.
If it’s checked for the primary viewport after which the viewport is copied or the web page is duplicated, these subsequent viewports would have Precerve Scale checked, too.
May be arrange in a template if in case you have a proxy SketchUp file as a part of it.
It’s not good follow to click on into the viewport to zoom in LayOut. It disconnects the viewport’s Digicam properties from the mannequin and creates different issues. Greatest could be to resize the viewport by dragging its edges or corners and if applicable, set the Scale for Parallel Projection views. Go away the Digicam Properties unmodified (no Reset button in that part of the SketchUp Mannequin panel.)
Thanks @DaveR. I take advantage of a plugin that exports my SU mannequin to Structure and the plugin was setting the dimensions. Earlier variations of SU with the identical plugin didn’t test the Protect Scale possibility. SU2023 appears to have it checked when a scale is utilized. I’ve resolved the difficulty by turning off the dimensions on the SU aspect when the plugin exports to Structure.
I’m marking this resolved.
Can anybody establish the place I’m going fallacious with this?
Structure window to sketchup altering scale following an replace inside sketch up, see photographs under:
