Hello all.
I’ve designed this and 3d printed it.
However the upright half is sitting on high of the bottom and so is a really weak joint.
How do I design the mannequin in order that the printer begins printing the up rights inside the bottom for a stronger repair.
It’s so darkish it’s exhausting to see what you’ve acquired happening. It could assist for those who share the .skp file. I think this isn’t actually a SketchUp factor anyway. SketchUp doesn’t management the way in which the printer provides options. Possibly it’s good to rotate the half for printing.
Seems like an attention-grabbing design drawback however, as @DaveR talked about, your image makes it unimaginable to inform what is going on.
Ought to the factor be modelled in two elements, the bottom with holes and the upright with pegs that slot in?
