3D file Tarantula All Terain Fight Car (Pre-supported)・3D printing mannequin to obtain・Cults

Unsupported Solely Model is Free on my Patreon

That is the pre-supported model (additionally included unsupported model).

For some time I have been dabbling in 3D modelling hoping to make some attention-grabbing issues that I can print myself. Again within the day I performed a little bit of WH40K and related video games and all the time needed to start out making my very own tabletop gaming items.

I am going to admit this is not as complicated or fantastical a design as lots of these fashions are (not less than these days), partially as a result of I am nonetheless a novice at modelling and likewise as a result of I are likely to get pleasure from a extra “trendy” or streamlined aesthetic.

Due to this, it could not readily match into one of many extra established tabletop universes which can be fashionable in the meanwhile, however I actually loved how this turned out on the tabletop, and thought I would share it with anybody who thinks it is cool and wish to make one for themselves.

In the intervening time, I’ve determined to provide away the unsupported model without spending a dime, and to cost what I hope is a reasonably low value of $7 for the pre-supported model. I am not a assist professional by any means, however they work, aren’t utterly ludicrous, and I believed it might be steadiness of giving everybody who desires to an opportunity to obtain this mannequin whereas nonetheless serving to me out a bit, what with the time I’ve put into this!

I would like to see folks’s makes if anybody decides this factor is price printing, and would love any constructive suggestions on the mannequin, helps, and this web page on the whole. And be happy to take a look at my (very naked in the meanwhile) Patreon!

Dimensions:
-Is dependent upon the way you set the legs, however about 80mm x 150mm x 140

Physique and Turret are pre-hollowed, with loads of area inside for magnets to be used with the legs, turret, secondary weapon if desired

I’ve printed this on an Anycubic Photon Mono X (4K) with the next settings:

-Layer peak 0.025mm
-Publicity time: 1.25sec
-Elevate pace: 180mm/min (right down to 120mm/min if I’ve loaded my plate)
-Remainder of settings are default

Whole Resin Utilization (Pre-supported model): About 260ml

I’ve uploaded guides for meeting, and a readme with some common ideas for printing in case anybody’s .