Hello All,
I’m busy doing a library of dynamic cabinets and have run into an issue with drawer entrance Heights. When clicking on the main points and apply, DR FRONT 1 modifications from one dimension to a different on every utilized click on? By no means had this earlier than. It must be dad or mum peak minus DR FRONT then Divide by 2 and minus .3mm.
Regard Vaughan
Untitled 1.skp (794.4 KB)
Hello Ryan, thanks for that, downloaded your file and see that it really works completely. Modified my one to 0.3 and it’s nonetheless doing the identical factor! On all of my different dynamic cabinets I’ve by no means used the 0. Actually obtained me confused.
Did you alter all of them or simply that one? I modified all of them, it’s good apply to make use of the 0 not simply the .